The dust extraction arm supplier may pulse dust removal according to an automatic control procedure at a specified time or resistance value. After the dust extraction arm supplier enters the single machine, the dust goes through two stages of filtration. The reduction of gas velocity and the change of air flow direction make the large particles of dust settle in the dust collection box due to the action of gravity and inertia. If the product falls into the user's bin, hopper and other equipment; The lighter and finer dust is blocked in the bag wall by the filter bag, and the clean air after purification is sent back to the workshop by centrifugal force, thus reducing heat loss.
Notes for daily inspection of dust extraction arm supplier:
1. Constantly observe the direction and rotation speed of the dust extraction arm supplier's fan, as well as the changes in vibration frequency and temperature.
Second, when we install the filter bag, we should pay attention to whether the installed filter belt is loose or bag off and some wear and other phenomena. If the filter bag is damaged, it depends on whether there is ash leakage or the filter bag is not smooth. If there is, it should be stopped immediately for replacement.
3. In the process of dust removal, we should closely observe the change of the whole time and cycle of dust removal, because this is the main condition that determines whether the dust extraction arm supplier can operate normally. If it takes a long time to clean the dust, we need to clean the dust attached to the dust extraction arm supplier, so as to determine the normal operation of the filter bag, and mainly to avoid premature damage to the filter bag.
The function of the dust extraction arm supplier depends on the filtered wind speed of the wet air in practice. Therefore, if the treatment temperature of the dust extraction arm supplier is determined and the cooling of the gas is diluted, Then the dust extraction arm supplier's handling air volume at this temperature, plus the diluted air volume. When calculating the required filtration area, the filtration speed is the practical filtration speed. It is the change of the customary dust source. When several reserve air volumes need to be added on top of the normal air volume in the dust collector planning, the dust extraction arm supplier should be planned according to the high air volume. If the dust extraction arm supplier works under conditions that exceed the regular treatment air volume and filtration speed, the pressure loss will be greatly increased, the press cloth may be blocked, the dust removal power will also decrease, and even become the cause of the sharp rise in the frequency of other faults. However, if the reserve air volume is too large, the investment cost and working cost of single boiler dust collector will be added.
The dust extraction arm supplier has six standards. The structure of the supplier shall consist of filtration chamber, filter bag, clean gas chamber, ash hopper, ash discharging equipment, pulse jet ash cleaning equipment, electric control box, etc. All the boxes shall be welded structures. The access door should be sealed. The dust extraction arm supplier is a small cloth bag dust collector that absorbs similar products and plans it after improvement. Widely used in metallurgy, building materials, machinery, chemical, mining and other industrial and mining enterprises non-fiber industrial dust removal purification and material recovery. dust extraction arm supplier achieves the purpose of dust removal by adopting electric bag combined dust removal technology. This technology combines the advantages of electric dust removal and filter cylinder dust removal, resulting in good purification effect and good working speed. Its working principle is to use the high pressure characteristics of electric dust removal, dust, particles and other impurities under the action of electric field force to produce opposite electricity, so as to filter out a large amount of dust, followed by the power bag composite dust removal technology has a stable pressure difference, reduce the consumption of wind energy, can control the discharge of dust, play the effect of dust removal.
The dust extraction arm supplier is a dust removal equipment that can collect dust in situ and solve it in situ. Therefore, before the dust extraction arm supplier is formally put into use, the corresponding debugging and inspection work should be done. So before the formal operation, or do all the detection again, to determine the normal operation of each component. However, when it is put into use, it is not only necessary to have regular routine inspection, but also to pay attention to several places prone to failure, such as the dust extraction arm supplier's cloth bag. At the same time, the speed and changes of each time the dust extraction arm supplier runs while working should be recorded.
dust extraction arm supplier https://www.kaisenfilter.com/Suspended-Suction-Arm
